Coding Infusions, Injections, and Hydration (96360-96379)

Code sets: CY 2026 CPT and HCPCS Level II.

Drug administration coding trips up new and experienced coders alike. These are the rules that matter most for CPT 96360-96379 (hydration and therapeutic, prophylactic, and diagnostic injections and infusions). Chemotherapy and other highly complex drug administration (96401-96549) follows similar logic but has its own codes.

Hydration vs. therapeutic infusion

  • Hydration (96360, +96361) is a prepackaged fluid and electrolyte solution (for example, normal saline) given to treat or prevent dehydration. Hydration must run more than 30 minutes to be reported; 96360 covers 31 minutes to 1 hour, and +96361 covers each additional hour (more than 30 minutes beyond the prior hour).
  • Therapeutic, prophylactic, or diagnostic infusion (96365-96368) is a drug or substance infused for treatment or diagnosis. An infusion must last more than 15 minutes; 96365 covers the initial service up to 1 hour, and +96366 covers each additional hour.
  • An infusion of 15 minutes or less is reported as an IV push (96374, +96375, +96376).

Fluid used only to administer a drug (a keep-open line or the diluent for a drug) is not reported as hydration.

Initial vs. subsequent

Only one initial service code is reported per encounter unless the protocol requires two separate IV sites. Everything after that is reported with the add-on codes for sequential (+96367), concurrent (+96368), subsequent push (+96375, +96376), or additional hydration (+96361).

Which service is “initial”

  • Physician or other QHP reporting: the initial code describes the key or primary reason for the encounter, regardless of the order in which the services were given.
  • Facility reporting: follow the hierarchy. Chemotherapy services rank above therapeutic infusions and injections, which rank above hydration. Within that, infusions rank above pushes, and pushes rank above injections. See the Medicare Claims Processing Manual, Chapter 4, Section 230.2 and the CPT drug administration guidelines.

Documentation to look for

  • Start and stop times for every infusion and hydration.
  • The substance, dose, and route.
  • Separate IV sites, if more than one.
  • The medical reason for hydration.

Without start and stop times, you cannot support an infusion code or the add-on hours. Medicare contractors apply the same timing rules: an infusion must run more than 15 minutes, and hydration of 30 minutes or less is not separately billable (CMS Billing and Coding Article A53778).

Do not forget the drug

Report the drug or substance separately with the appropriate HCPCS Level II J code and units, unless the payer bundles it. Check the HCPCS descriptor for the dose per unit before calculating units.

Refreshed from the CCO Community archive, November 2026.

CCO Hero

Know someone starting a medical coding career?

Share your personal CCO link. Your friend saves 20% on their first course or practice exam of $100 or more, and you earn 5% cash on their first enrollment over $100.

Become a CCO Hero
Photo of author

Laureen Jandroep

Leave a Comment

Clinical Doc Guides

⚊